Camry XLE Sedan L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
_mfi/Page-1314004.png)
2. RIGHT-HAND DRIVE SHAFT: ASSEMBLE INBOARD JOINT SHAFT
a. Install a new snap ring to the inboard joint shaft.
b. Using a press, install a new bearing.
c. Using a snap ring expander, install a new snap ring.
d. Using SST, an extension bar and press, install a new dust cover.
SST 09506-35010
HINT: The clearance between the dust cover and the bearing should be kept in the range shown in the illustration.
3. INSTALL DUST COVER
-
(Left-Hand drive shaft)
Using a press, install a new dust cover.
-
(Right-Hand drive shaft)
Using a press, install a new dust cover until the distance from the tip of the inboard joint shaft to the dust cover falls within the specification, as
shown in the illustration.
