Celica L4-1.8L (2ZZ-GE) (2005)
2. DENSO Made: ASSEMBLE SST
SST 09230-01010
a. Install the claw to the overhaul handle, inserting it in the hole in part "A" as shown in the diagram.
b. While gripping the handle, adjust the stopper bolts so that dimension "B" shown in the diagram is 0.2 - 0.3 mm (0.008 - 0.012 inch).
NOTICE: If this adjustment is not done the claw may be damaged.
3. DENSO Made: UNCAULK LOCK PLATES
Using SST to release the caulking, squeeze the handle until stopped by the stopper bolts.
SST 09230-01010
4. DENSO Made: REMOVE TANKS AND O-RING
Lightly tap the bracket of the radiator (or radiator inlet or outlet) with a soft-faced hammer, and remove the tank and the O-ring.
5. A/T (DENSO Made): REMOVE OIL COOLER FROM LOWER TANK
a. Loosen the nut, and remove the cooler pipe.
b. Remove the 2 nuts and 2 plate washers.
c. Remove the oil cooler and 2 O-rings.
INSPECTION
DENSO Made: INSPECT LOCK PLATE FOR DAMAGE