Celica L4-1.8L (2ZZ-GE) (2005)
c. Install the grommet and O-ring to the injector.
d. Connect SST (union and hose) to the injector, and hold the injector to prevent gasoline from splashing out.
SST 09268-41047
e. Put the injector into a graduated cylinder.
HINT: Install a suitable vinyl tube onto the injector to prevent gasoline from splashing out.
f.
Connect the TOYOTA hand-held tester to the DLC3.
g. Turn the ignition switch ON and TOYOTA hand-held tester main switch ON.
NOTE: Do not start the engine.
h. Select the active test mode on the TOYOTA hand-held tester.
i.
Please refer to the TOYOTA hand-held tester operator's manual for further details.
j.
If you have no TOYOTA hand-held tester, connect the positive (+) and negative (-) leads from the battery to the fuel pump connector.
k. Connect SST (wire) to the injector and battery for 15 seconds, and measure the injection volume with a graduated cylinder. Test each injector
2 or 3 times.
SST 09842-30080
Volume: 47 - 58 cu.cm (2.7 - 3.3 cu in.) per 15 sec.
Difference between each injector: 10 cu.cm (0.6 cu in.) or less
If the injection volume is not as specified, replace the injector.
2. INSPECT LEAKAGE