Celica L4-1.8L (2ZZ-GE) (2005)
6. REMOVE CONSOLE BOX
7. REMOVE END FINISH PANEL LH
8. REMOVE END FINISH PANEL RH
9. REMOVE AIRBAG SENSOR ASSEMBLY
a. Disconnect the airbag sensor connectors.
NOTE: Disconnect the connectors with the airbag sensor assembly installed.
b. Using a Torx(R) wrench, remove the 3 screws and airbag sensor assembly.
Torx wrench: T40 (Part No.09042-00020 or locally manufactured tool)
INSTALLATION
NOTE:
-
Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
-
Never reuse the airbag sensor assembly involved in a collision when the airbag has deployed.
-
Never repair a sensor in order to reuse it.
1. INSTALL AIRBAG SENSOR ASSEMBLY
a. Using a Torx(R) wrench, install the airbag sensor assembly with the 3 screws.