Celica L4-1.8L (2ZZ-GE) (2005)
/Page-795004.png)
3. REMOVE UPPER SUSPENSION ARM
a. Place matchmarks on both the cam plate and suspension member.
b. Remove the nut, cam plate and cam bolt.
Torque: 74 Nm (755 kgf-cm, 55 ft. lbs.)
HINT: At the time of installation, after stabilizing the suspension, torque the nut.
c. Remove the bolt, nut and upper suspension arm.
Torque: 74 Nm (755 kgf-cm, 55 ft. lbs.)
NOTICE: Do not turn the nut.
HINT: At the time of installation, after stabilizing the suspension, torque the bolt.
INSTALLATION
Installation is in the reverse order of removal.
HINT: After installation, check the rear wheel alignment.