Celica L4-1.8L (2ZZ-GE) (2005)
b. Start and idle the engine.
c. Without depressing the clutch pedal, slowly shift the shift lever into reverse position until the gears contact.
d. Gradually depress the clutch pedal and measure the stroke distance from the point the gear noise stops (release point) to the full stroke end
position.
Standard distance: 25 mm (0.98 inch) or more (From pedal stroke end position to release point)
If the distance is not as specified, perform the following operations.
^
Inspect pedal height.
^
Inspect push rod play and pedal free play.
^
Bleed the clutch line.
^
Inspect the clutch cover and disc.
6. CHECK CLUTCH START SYSTEM
a. Check that the engine does not start when the clutch pedal is released.
b. Check that the engine starts when the clutch pedal is fully depressed.
If necessary, replace the clutch start switch.
7. INSPECT CLUTCH START SWITCH CONTINUITY
Check the continuity between terminals when the switch is ON and OFF.