Celica L4-1.8L (2ZZ-GE) (2005)
Drive shaft standard length
(3) Bend the band and lock the inboard joint boot clamps with a screwdriver.
(4) Secure the 2 outboard joint boot clamps onto the boot.
(5) Place SST onto the outboard joint large boot clamp.
SST 09521-24010
(6) Tighten the SST so that the large clamp is pinched.
NOTICE: Do not overtighten the SST.
(7) Using SST, adjust the clearance of the large clamp.
SST 09240-00020
Clearance: 1.2 - 4.0 mm (0.047 - 0.157 inch)
(8) Employ the same manner to the outboard joint small boot clamp.
f.
M/T: Assemble the dynamic damper clamp.
(1) Set the dynamic damper distance, as described.
Distance: 155.0 ± 2.0 mm (6.102 ± 0.079 inch)
(2) Bend the band and lock the dynamic damper clamp with a screwdriver.
4. CHECK DRIVE SHAFT