Celica 2WD L4-2.0L (3S-FE) (1988)
Lower Side Moulding / Trim: Technical Service Bulletins
Exterior Trim - Body Side Moldings Removal/Replacement
REFERENCE BODY
NUMBER 018
DATE
06-10-88
MODEL
ST165
TITLE BODY SIDE PANELS (MOULDINGS) REMOVAL/REPLACEMENT
When the body side panels (mouldings) require removal or replacement, use the following steps:
1.
Remove the following components to gain access to the attaching hardware:
REMOVE:
TO ACCESS ATTACHING SCREWS FOR:
Front Fender Liner
Rocker panel-front moulding
Inside Quarter Trim Panel
Rocker panel-rear moulding
Front Door Trim Panel
Door outside moulding
FIGURE 1
2.
Remove all attaching nuts and screws and keep them for reinstallation. The location of this hardware is shown in (Fig. 1).
Figure 2
3.
Remove the round plastic retaining clips using the following methods:
(a)
Cut off the clip retaining tabs one by one until the plastic clip falls away from the locating pin. (Fig. 2)