Celica 2WD L4-2.0L (3S-FE) (1988)
8. Remove engine RH mounting insulator and bracket.
(a) Remove the through bolt, two nuts and mounting insulator.
(b) Remove the three bolts and bracket.
9. Remove spark plugs.
10. Remove No.2 timing belt cover bolts, belt cover and gaskets.
11. Set No.1 cylinder to TDC/Compression.
(a) Turn the crankshaft pulley and align its groove with the timing mark "0" of the No.1 timing belt cover.
(b) Check that the hole of the camshaft timing pulley is aligned with the alignment mark of the bearing cap. If not, turn the crankshaft one
revolution (360°).