Celica 2WD L4-2.0L (3S-FE) (1988)
![background image](/toyota/celica_2wd/l4-2.0l_(3s-fe)/Page-947004.png)
c. Connect the stator lead wires to the compressor housing.
2. Install rotor.
a. Install the rotor on the compressor shaft.
b. Using SST 07114-84020 install the new snap ring.
3. Install pressure plate.
a. Put the shims to the pressure plate.
b. Using SST 07112-76060 and torque wrench, install the shaft bolt.
Torque: 14 Nm (10 ft lb)
4. Check clearance of magnetic clutch. Check the clearance between the pressure plate and rotor using thickness gauge.
Standard clearance: 0.5 +/- 0.15 mm (0.020 +/- 0.0059 in.)
If the clearance is not with tolerance, add or reduce the number of shims to obtain the standard clearance.