Celica GT-S L4-1.8L (2ZZ-GE) (2000)
/Page-843003.png)
14. INSTALL APPLY GASKET
a) Coat 3 new apply gaskets with ATF.
b) Install the gaskets to the transaxle case.
15. INSTALL CHECK VALVE AND SPRING
16. INSTALL VALVE BODY
a) Align the groove of the manual valve with the pin of the manual valve lever.
b) Temporarily install the valve body with the 17 bolts.
Bolt length:
Bolt A: 25 mm (0.98 inch)
Bolt B: 41 mm (1.61 inch)
Bolt C: 45 mm (1.77 inch)
c) Check that the manual valve lever contacts the center of the roller at the tip of the detent spring.
d) Tighten the 17 bolts.
Torque: 11 Nm (110 kgf-cm, 8 ft. lbs.)
17. CLAMP WIRE HARNESS TO 2 CLAMPS
18. INSTALL ATF TEMPERATURE SENSOR
Install the ATF temperature sensor with the lock plate and bolt.
Torque: 6.6 Nm (67 kgf-cm, 58 inch lbs.)
19. CONNECT 5 SHIFT SOLENOID VALVE CONNECTORS
