Celica GT-S L4-1.8L (2ZZ-GE) (2000)
/Page-856005.png)
-
Whether inboard joint shaft is in contact with pinion shaft or not can be known from the sound or feeling.
-
After installation, check that there is 2 - 3 mm (0.08 - 0.12 inch) of play in the axial direction.
-
After installation, check that the drive shaft cannot be removed by hand.
b. Using a screwdriver, remove the snap ring from the inboard joint shaft.
INSTALLATION
Installation is in the reverse order removal.
HINT: After installation, check the ABS speed sensor signal and front wheel alignment.
