Celica GT-S L4-1.8L (2ZZ-GE) (2000)
a. Temporarily install dynamic damper (M/T), new outboard and inboard joint boots and new clamps.
HINT: Before installing the boots, wrap the spline of the outboard joint shaft with vinyl tape to prevent them from being damaged.
1. Place 2 new clamps on a new outboard joint boot and install them to the outboard joint shaft.
2. M/T: Place new clamp on the dynamic damper and install them to the outboard joint shaft.
3. Place 2 new clamps on a new inboard joint boot and install them to the outboard joint shaft.
b. Assemble the outboard joint shaft.
1. Install the cage to the outboard joint shaft.
NOTICE: The side with smaller diameter must face outboard joint.
2. Align the matchmarks on the inner race and outboard joint shaft.
3. Using a brass bar and hammer, tap in the inner race to the outboard joint shaft.
NOTICE: Be careful not to damage the inner race.
4. Using a snap ring expander, install a new snap ring.
5. Align the matchmarks on the cage and inner race.
6. Install the cage to the inner race.