Celica GT L4-1.8L (1ZZ-FE) (2001)
a. Clean the contacting surface of the axle hub and a new speed sensor.
NOTICE: Do not stick any foreign objects to the sensor rotor.
b. Place the speed sensor on the axle hub so that the connector makes the most downward position under the on-vehicle condition.
c. Using SST and a press, install a new speed sensor to the axle hub.
SST 09214-76011
NOTICE:
^
Do not tap the speed sensor with a hammer directly.
^
Check that there should be no foreign objects on the speed sensor detection portion.
^
Press in the speed sensor straight and slowly.
2. INSTALL SPEED SENSOR WITH REAR AXLE
3. CONNECT SPEED SENSOR CONNECTOR
4. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
5. CHECK SPEED SENSOR SIGNAL.