Celica GT L4-1.8L (1ZZ-FE) (2001)
Alignment: Service and Repair
Front Wheel Alignment
INSPECTION
1. MEASURE VEHICLE HEIGHT
Vehicle height:
*1: Front measuring point
Measure the distance from the ground to the center of the front side lower suspension arm mounting bolt.
*2: Rear measuring point
Measure the distance from the ground to the center of the rear side lower suspension arm suspension member side set bolt.
NOTICE: Before inspecting the wheel alignment, adjust the vehicle height to the specified value.
If the vehicle height is not the specified value, try to adjust it by pushing down on or lifting the body.
2. INSTALL CAMBER-CASTER-KINGPIN GAUGE OR POSITION VEHICLE ON WHEEL ALIGNMENT TESTER
Follow the specific instructions of the equipment manufacturer.
3. INSPECT CAMBER, CASTER AND STEERING AXIS INCLINATION
Camber, caster and steering axis inclination: