Celica GT L4-1.8L (1ZZ-FE) (2001)
COMPONENTS
REMOVAL
NOTE:
-
If the wiring connector of the SRS is disconnected with the ignition switch at ON position, DTCs will be recorded.
-
Never use SRS parts from another vehicle. When replacing parts, replace them with new parts.
-
Never reuse the sensor involved in a collision when the SRS has deployed.
-
Never repair a sensor in order to reuse it.
1. LH:
REMOVE FRONT AIRBAG SENSOR
a. Remove the air cleaner hose.
b. Remove the air cleaner cap.
c. Remove the air filter.
d. Remove the 2 bolts and air cleaner case.
e. Disconnect the connector.
NOTE: Disconnect the connector with sensor assembly installed.
f.
Remove the 2 bolts and front airbag sensor LH.
2. RH:
REMOVE FRONT AIRBAG SENSOR
a. Remove the 5 clips and upper front fender apron seal.
b. Disconnect the connector.
NOTE: Disconnect the connector with sensor assembly installed.
c. Remove the 2 bolts and front airbag sensor RH.
INSTALLATION