Celica GT Convertible L4-2164cc 2.2L DOHC MFI (1997)
Front Crankshaft Seal: Service and Repair
NOTE: There are 2 methods (A and B) to replace the oil seal which are as follows:
1. Replace crankshaft front oil seal.
A. If oil pump is removed from cylinder block:
(a)
Using a screwdriver and hammer, tap out the oil seal.
(b) Using Special Service Tool (SST) Crankshaft Front & Rear Bearing Replacer # 09226 - 10010 or equivalent and a hammer, tap in a new
oil seal until its surface is flush with the oil pump body edge.
(c)
Apply Multipurpose (MP) grease to the oil seal lip.
B. If oil pump is installed to the cylinder block:
(a)
Using a knife, cut off the oil seal lip.
(b) Using a screwdriver, pry out the oil seal.
CAUTION: Be careful not to damage the crankshaft. Tape the screwdriver tip.
(c)
Apply MP grease to a new oil seal lip.
(d) Using SST Crankshaft Front & Rear Bearing Replacer # 09226 - 10010 or equivalent and a hammer, tap in the oil seal until its-, surface is