Celica GT Convertible L4-2164cc 2.2L DOHC MFI (1997)
Ignition Cable: Testing and Inspection
HIGH-TENSION CORDS INSPECTION
1. REMOVE HIGH-TENSION CORDS
Disconnect the high-tension cords at the rubber boot. Do not pull on the high-tension cords.
NOTICE: Pulling on or bending the cords may damage the conductor inside.
2. INSPECT HIGH-TENSION CORD RESISTANCE
Using an ohmmeter. measure the resistance.
Maximum resistance: 25 K ohms per cord
If the resistance is greater than maximum, check the terminals. If necessary, replace the high-tension cord.
3. REINSTALL HIGH-TENSION CORDS