Celica GT Convertible L4-2164cc 2.2L DOHC MFI (1997)
Alignment: Service and Repair
Rear
1. Measure the vehicle height.
2. Inspect the camber. The measurements should be as follows.
Camber: -1°16' ± 45' (-1.27° ± 0.75°).
Left- Right Error: 45' (0.75°) or less.
NOTE: Camber is not adjustable, if measurement is not within specification, inspect and replace the suspension parts as necessary.
Measuring Point Reference
3. Inspect the toe-in. The Toe-In (total) measurements should be as follows.
A + B: 0°21' ± 12' (0.35° ± 0.2°).
C - D: 3.5 mm ± 2mm (0.14 inch ± 0.08 inch).
4. If the toe-in is not within the specification, adjust it at the No.2 lower suspension arm.
5. Adjust the toe-in by doing the following
a. Measure the length of the left and right No.2 lower suspension arms. The left-right difference should be 1 mm (0.04 inch) or less, if the
left-right difference is greater than the specification, adjust the length.
b. Loosen the lock nuts.