Celica GT Convertible L4-2164cc 2.2L DOHC MFI (1997)
2. Connect the pressure feed tube and tighten the union bolt with a new gasket, making sure the stopper of the tube is touching the power steering
vane pump body, as shown, then tighten the bolt to 52 Nm (38 ft. lbs.)
3. Connect the return hose.
4. Install the drive belt, and do the following.
a. Adjust drive belt tension.
See: Testing and Inspection/Component Testing/Drive Belt Tension check
b. Tighten the two bolts to 39 Nm (29 ft. lbs.).
5. Install the right side engine under cover then tighten the nine bolts.
6. Bleed the power steering system.
See: Power Steering Bleeding/Service and Repair
