Celica GT Liftback L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
3. MEASURE DISC RUNOUT
Using a dial indicator, measure disc runout at a position 10 mm (0.39 inch) from the outside edge.
Maximum disc runout: 0.15 mm (0.0059 inch)
If the disc's runout is at the maximum value or greater, check the bearing play is in the axial direction and check the axle hub runout. If the bearing
play and axle hub runout are not abnormal, adjust the disc runout or grind it on a "On-car" rake lathe.
Removal Of Torque Plate
4. IF NECESSARY, ADJUST DISC RUNOUT
a. Remove the 2 bolts and torque plate.
b. Remove the hub nuts and the disc. Reinstall the disc in the position turned 1/5 from its original position on the hub. Install and torque the hub
nuts.
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
Remeasure the disc runout. Make a note of the runout and the disc's position on the hub.
c. Repeat (b) until the disc has been installed on the 3 remaining hub positions.
d. If the minimum runout recorded in (b) and (c) is less than 0.15 mm (0.0059 inch), install the disc in that position.
e. If the minimum runout recorded in (b) and (c) is greater than 0.15 mm (0.0059 inch), replace the disc and repeat step 3.
f.
Install the torque plate and torque the mounting bolts.
Torque: 47 Nm (475 kgf-cm, 34 ft. lbs.)
REASSEMBLY
Reassembly is in the reverse order of disassembly.
NOTICE: Apply lithium soap base glycol grease to the parts indicated by the arrows. See: Diagrams