Celica GT Liftback L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
a
Disconnect the wire from the clamp on the rear end cover.
b
Disconnect the generator connector.
c
Remove the rubber cap and nut, and disconnect the generator Wire
NOTE: Perform on-vehicle inspection.
d
Loosen the adjusting lock bolt (w/ A/C), adjusting bolt and pivot bolt.
Torque:
Pivot bolt 54 Nm (530 kgf.cm, 40 ft.lbf)
Adjusting lock bolt (w/ A/C) or Adjusting bolt (w/o A/C) 19 Nm (185 kgf.cm, 14 ft.lbf)
e
Remove the drive belt
HINT: Adjust the drive belt.
f
Remove the adjusting lock bolt (w/ A/C) or adjusting bolt (w/o A/C) and pivot bolt.
HINT: Do not tighten the bolts yet.
g
Remove the generator.
INSTALLATION
Installation is in the reverse order of removal.