toyota Workshop Repair Guides

Toyota Workshop Service and Repair Manuals

Starter Motor|Removal and Installation|Page 4522 > < Starter Motor|Removal and Installation|Page 4520
Page 3
background image

HINT:  Face the arrow mark on the hold-down clamp forward.

3. w/ Cruise Control System:

DISCONNECT CRUISE CONTROL ACTUATOR FROM BODY BRACKET
a. Disconnect the actuator connector.
b. Remove the 3 bolts, and disconnect the actuator from the body bracket.

4. REMOVE STARTER

a. Disconnect the starter connector.
b. Remove the nut, and disconnect the starter cable.

c. Remove the 2 bolts.

Torque: 37 Nm (380 kgf.cm, 28 ft.lbf)

d. Disconnect the oxygen sensor connector and engine wire brackets from the starter.
e. Remove the starter.

INSTALLATION

Installation is in the reverse order of removal.

Starter Motor|Removal and Installation|Page 4522 > < Starter Motor|Removal and Installation|Page 4520