Celica GT Liftback L4-2164cc 2.2L DOHC (5S-FE) MFI (1999)
NOTE: Check that the positive (+) lead wires are not grounded.
6. REMOVE ARMATURE FROM FIELD FRAME
REPLACEMENT
1. REMOVE MAGNETIC SWITCH END COVER
Remove the 3 bolts, end cover, gasket and plunger.
2. INSPECT CONTACT PLATE FOR WEAR
Using vernier calipers, measure the contact plate for depth of wear.
Maximum wear: 0.9 mm (0.035 in.)
If the depth of wear is greater than the maximum, replace the contact plate.
3. REMOVE TERMINAL KIT PARTS
a. Using SST, loosen the terminal nuts.
SST 09810-38140
b. Terminal C:
Remove the terminal nut, wave washer, terminal insulator (outside), O-ring, terminal bolt, contact plate and terminal insulator (inside).
c. Terminal 30:
Remove the terminal nut, wave washer, terminal insulator (outside), packing, ring, terminal bolt, contact plate, terminal insulator (inside) and
insulation paper.
4. REINSTALL TERMINAL KIT PARTS