Celica GT Ltd Ed Convertible L4-2164cc 2.2L DOHC MFI (1997)
Electronic Brake Control Module: Testing and Inspection
NOTE: - Tools Required:
-
TOYOTA break-out-box, or equivalent.
-
TOYOTA hand-held tester, or equivalent.
1. Turn the Ignition Switch OFF.
Hand-Held Tester And Break-Out-Box
2. Hook up the break-out-box and hand-held tester to the vehicle.
3. Turn the Ignition Switch ON.
4. Read the ECU input/output values by following the prompts on the tester screen.
NOTE:
-
Hand-held tester has a "Snapshot" function. This records the measured values and is effective in the diagnosis of intermittent problems.
-
Please refer to the hand-held tester/break-out-box operator's manual for further details.
-
Using SST 09843-18020, connect the terminals Tc and E1, and remove the short pin.
-
If any abnormality is not found when inspection parts, inspect the ECU.
-
If a malfunction code is displayed during the DTC check, check the circuit listed for that code.
