Celica Liftback L4-107.5 1762cc 1.8L DOHC (7A-FE) (1995)
(d) Clean the crank pin and bearing.
(e) Check the crank pin and bearing for pitting and scratches.
If the crank pin or bearing is damaged, replace the bearings. If necessary, grind or replace the crankshaft.
(f) Lay a strip of Plastigage across the crank pin.
(g) Install the connecting rod cap with the 2 bolts.
Torque:
1st: 25 N.m (250 kgfcm, 18 ft.lbf)
2nd: Turn extra 90 degrees
NOTICE: Do not turn the crankshaft.
(h) Remove the 2 bolts, connecting rod cap and lower bearing. (See procedure (b) and (c) above)