Celica ST Ltd Ed Liftback L4-1762cc 1.8L DOHC MFI (1997)
Remove Clamp Bolts
(c) Remove the 2 clamp bolts holding the sensor wire harness to the body and suspension Shock Absorber.
Torque: 5 Nm (44 inch lbs.)
2. Remove Speed Sensor.
Remove Speed Sensor
Remove the Speed Sensor from the Axle Carrier.
Torque: 8 Nm (71 inch lbs.)
NOTE: Make sure that:
^
There are no foreign objects on the sensor or the part of the knuckle to which the sensor is to be installed.
^
The sensor is installed flat against the knuckle when you tighten the bolt.
INSTALLATION
Installation is in the reverse order of removal.
NOTE: After installation, check Speed Sensor signal.