Celica Supra L6-2759cc 5M Ser (1982)
Check Connecting Rod Thrust Clearance
2. Measure the connecting rod thrust clearance. If it exceeds 0.012 in. (0.3mm) then replace the connecting rod.
Place Matchmark On Cap And Connecting Rod
3. Place matchmarks on the cap and connecting rod. Remove the nuts, connecting rod end cap and lower bearing.
Cover Rod Bolts With Short Piece Of Hose
4. To prevent damage to the cylinder wall, cover the connecting rod bolts with a short piece of hose.
5. Slide the piston and connecting rod assembly up through the top of the cylinder block.
Installation
Cover Connecting Rod Bolts
1. Cover the rod bolts with a small piece of hose.
