Corolla L4-1.8L (1ZZ-FE) (2004)
Alignment: Service and Repair
Front Wheel Alignment
NOTICE: For Zero Point Calibration information, please refer to: TSB T-SB-0020-8 (3/25/08).
ADJUSTMENT
1. INSPECT TIRE
2. MEASURE VEHICLE HEIGHT
Vehicle height
Measuring points:
A: Ground clearance of front wheel center
B: Ground clearance of lower suspension arm front bolt center
C: Ground clearance of axle beam set bolt center
D: Ground clearance of rear wheel center
NOTICE: Before inspecting the wheel alignment, adjust the vehicle height to the specified value.
If the vehicle height is not the specified value, try to adjust it by pushing down on or lifting the body.
3. INSPECT TOE-IN
Toe-in
If the toe-in is not within the specified value, adjust it at the rack ends.
4. ADJUST TOE-IN
a. Remove the rack boot set clips.
b. Loosen the tie rod end lock nuts.
c. Turn the right and left rack ends by an equal amount to adjust the toe-in.
HINT: Try to adjust the toe-in to the center of the specified value.