Corolla L4-1.8L (1ZZ-FE) (2004)
Camber, caster and steering axis inclination
If the caster and steering axis inclination are not within the specified values, after the camber has been correctly adjusted, recheck the
suspension parts for damaged and/or worn out parts.
7. ADJUST CAMBER
NOTICE: After the camber has been adjusted, inspect the toe-in.
a. Remove the front wheel.
b. Remove the 2 nuts on the lower side of the shock absorber assy front LH.
NOTICE: When removing nut, stop the bolt from rotating and loosen the nut.
c. Clean the installation surfaces of the shock absorber assy front LH and the steering knuckle.
d. Temporarily install the 2 nuts.
e. Adjust the camber by pushing or pulling the lower side of the shock absorber in the direction in which the camber adjustment is required.
f.
Tighten the nuts.
Torque: 153 Nm (1,560 kgf-cm, 113 ft. lbs.)
g. Install the front wheel.
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)