Corolla L4-1.8L (1ZZ-FE) (2004)
a. Remove the 2 bolts, nut and front suspension arm sub-assy lower No.1 LH from the front suspension crossmember sub-assy.
10. TEMPORARY TIGHTEN FRONT SUSPENSION ARM SUB-ASSY LOWER NO.1 LH
a. Install the front suspension arm sub-assy lower No.1 LH, temporarily tighten the 2 bolts and nut.
11. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSY (LH (A/T) POSITION)
a. Lift the front suspension crossmember sub-assy up with a transmission jack.
b. Insert SST to the base hole of the RH side crossmember and RH side of the vehicle.
SST 09670-00010
c. Tighten the bolt temporarily in the order A and B.
d. Insert SST to the base hole of the LH side of crossmember and LH side of the vehicle.
SST 09670-00010
e. Tighten the bolt temporarily in the order A and B.
f.
Insert SST to the base hole of the RH side of crossmember and RH side of the vehicle.
SST 09670-00010
g. Then tighten the bolt A and B by the specified torque.
Torque:
Bolt A: 157 Nm (1,601 kgf-cm, 116 ft. lbs.)
Bolt B: 113 Nm (1,152 kgf-cm, 83 ft. lbs.)
h. Insert SST to the base hole of the LH side of crossmember and LH side of the vehicle.
SST 09670-00010
i.
Tighten the bolt A and B by the specified torque.
Torque:
Bolt A: 157 Nm (1,601 kgf-cm, 116 ft. lbs.)
Bolt B: 113 Nm (1,152 kgf-cm, 83 ft. lbs.)
j.
Connect the transverse engine engine mounting insulator and engine mounting member sub-assy center to the front suspension crossmember
sub-assy.