Corolla L4-1.8L (1ZZ-FE) (2004)
d. Connect the end of the shift cable to the shift lever assy.
e. Connect the shift cable to the retainer of shift lever assy, turn the lock.
NOTICE: The projecting part of the lock should face upward when the shift cable is installed.
f.
Install the cable outer spring to the lock.
NOTICE: Make sure that after installation the cable outer spring is moved to the place shown in the illustration.
g. Install the clamp with the 2 nuts.
Torque: 5.0 Nm (51 kgf-cm, 44 inch lbs.)
h. Connect the shift cable to the control cable bracket, install a new clip.
i.
Connect the shift cable to the transaxle, install the washer and clip.
7. INSTALL FRONT FLOOR HEAT INSULATOR NO.1
a. Install the heat insulator No.1 with the 3 nuts.
Torque: 5.5 Nm (56 kgf-cm, 49 inch lbs.)
8. INSTALL EXHAUST PIPE ASSY
9. CONNECT AIR BAG SENSOR ASSY CENTER
a. Install the airbag sensor assy center with the 3 bolts.
Torque: 17.5 Nm (178 kgf-cm, 13 ft. lbs.)
10. INSPECT SRS WARNING LIGHT