Corolla L4-1.8L (1ZZ-FE) (2004)
6.
Remove the front door trim board sub-assembly.
A.
Remove the three (3) screws.
B.
Using the taped screwdriver, disengage the eight (8) clips and pull the trim board upward to remove it.
HINT:
If the clip remover cannot reach the clips, pull on the lower trim to remove it.
7.
Remove the window run. Completely remove the double-sided tape remaining on the frame.
8.
Thoroughly clean the door frame using a white body shop towel and Kent(TM) Acrysol.
NOTE:
Do NOT use red shop towels. These towels contain silicone.
9.
Install the door glass window run.
A.
Position the glass run at the No. 2 and No. 3 corners of the door frame and then attach the middle part of the run.
B.
Insert the glass run into the window run channels.
NOTE:
^
Do NOT apply water or lubricant to the glass run when inserting it into the door.
^
Make sure the glass run fits securely into the holes of the door frame.
10.
Using a plastic pry tool, press the glass run into the upper portion of the door frame to securely adhere the double-sided tape.