Corolla L4-1.8L (2ZR-FE) (2009)
Ignition Switch: Testing and Inspection
Engine Switch
2ZR-FE STARTING: ENGINE SWITCH: INSPECTION
INSPECTION
1. INSPECT ENGINE SWITCH
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
If the result is not as specified, replace the engine switch.
(b) Apply battery voltage between the terminals of the switch and check the illumination condition of the switch.
OK:
NOTICE:
-
If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator light will not illuminate.
-
If the voltage is too low, the indicator light will not illuminate.
If the result is not as specified, replace the engine switch.