Corolla L4-1.8L (2ZZ-GE) (2005)
/Page-1125003.png)
2.
Drill two (2) holes in both the passenger and driver's side grille areas as show in the illustration.
To ensure that the bumper does NOT get scratched by the tools, use tape on all exposed paint surfaces near the drilling locations. This is to ensure
the paint is protected from the drill and tools.
3.
Using 16 plastic zip ties and working from the centermost bottom fastener, fasten the plastic mesh to the backside of the bumper housing/bumper
grille at each bumper opening support.
^
Ensure that the plastic zip ties on the top side of the grille are placed as close to the top of the bumper opening support as possible.
^
Ensure that the plastic zip ties on the bottom side of the grille are placed as close to the bottom of the bumper opening support as possible.
^
Ensure that the head of the plastic zip tie fastener is rotated to the rear of the bumper opening away from view.
