Corolla L4-1.8L (2ZZ-GE) (2005)
b. Using a pin punch and hammer, drive out the 2 pins and remove the 2 attachments from SST
c. Using SST and 2 bolts (Diameter: 12 mm, pitch: 1.5 mm), remove the skid control sensor from the rear axle hub.
SST 09520-00031 (09520-00040), 09521-00020, 09950-00020
NOTICE:
^
If a damage is inflicted to the sensor rotor, replace the axle hub assembly.
^
Do not scratch the contacting surface of axle hub and speed sensor.
8. INSTALL SKID CONTROL SENSOR
a. Clean the contacting surface of the axle hub and a new speed sensor.
NOTICE: Do not stick any foreign objects to the sensor rotor.
b. Place the speed sensor on the axle hub so that the connector makes the lowest position under the on-vehicle condition.
c. Using SST and press, install the new speed sensor to the axle hub.
SST 09214-76011
9. INSTALL REAR AXLE HUB & BEARING ASSEMBLY LH
10. CONNECT SKID CONTROL SENSOR WIRE
a. Connect the skid control sensor wire connector to the skid control sensor.
11. INSTALL REAR DISC (DISC REAR BRAKE TYPE)
12. INSTALL REAR DISC BRAKE CALIPER ASSEMBLY LH (DISC REAR BRAKE TYPE)
13. INSTALL REAR BRAKE DRUM SUB-ASSEMBLY (DRUM REAR BRAKE TYPE)
14. INSTALL REAR WHEEL
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
15. INSPECT AND ADJUST REAR WHEEL ALIGNMENT
16. CHECK ABS SPEED SENSOR SIGNAL