Corolla L4-1.8L (2ZZ-GE) (2005)
d. Turn the crankshaft clockwise, then check that the slipper is pushed by the plunger.
HINT: If the plunger is not extended, push the slipper into the chain tensioner with a screwdriver so that the hook is released from the knock
pin and the plunger can be extended.
48. INSTALL CRANKSHAFT POSITION SENSOR
Torque: 9.0 Nm (92 kgf-cm, 80 inch lbs.)
49. INSTALL TRANSVERSE ENGINE ENGINE MOUNTING BRACKET
a. Install the engine mounting bracket with the 4 bolts.
Torque: 49 Nm (500 kgf-cm, 36 ft. lbs.)
50. INSTALL WATER PUMP ASSEMBLY
51. INSTALL WATER PUMP PULLEY
SST09960-10010 (09962-01000, 09963-00600)
52. INSTALL EXHAUST MANIFOLD
a. Install a new gasket and the exhaust manifold with the 4 bolts and 2 nuts.
Torque:
50 Nm (510 kgf-cm, 37 ft. lbs.) for bolt A and nut A
20 Nm (204 kgf-cm, 14 ft. lbs.) for bolt B
53. INSTALL EXHAUST MANIFOLD HEAT INSULATOR NO.1
Torque: 20 Nm (204 kgf-cm, 15 ft. lbs.)