Corolla L4-1.8L (2ZZ-GE) (2005)
/Page-404001.png)
Engine Control Module: Service and Repair
Removal and Installation
REPLACEMENT
1. DISCONNECT BATTERY NEGATIVE TERMINAL
2. REMOVE GLOVE COMPARTMENT DOOR ASSY
a. Remove the screw from the glove compartment door stoppers.
b. Deform the upper part of the glove compartment door assy to release the stoppers.
c. Pull the glove compartment door assy upward to remove it.
3. REMOVE ECM
a. Remove the 2 clips using a clip remover, then open the cover.
b. Disconnect the 4 ECM connectors.
c. Remove the wire harness from the wire harness clamp.
