Corolla L4-1.8L (2ZZ-GE) (2005)
Wheel Speed Sensor: Service and Repair
Skid Control Sensor
SKID CONTROL SENSOR
REPLACEMENT
HINT: Use the same procedures for the RH side and LH side. The procedures listed below are for the LH side.
1. REMOVE REAR WHEEL
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH (DISC REAR BRAKE TYPE)
3. REMOVE REAR DISC (DISC REAR BRAKE TYPE)
4. REMOVE REAR BRAKE DRUM SUB-ASSEMBLY (DRUM REAR BRAKE TYPE)
5. DISCONNECT SKID CONTROL SENSOR WIRE
a. Disconnect the skid control sensor wire connector from the skid control sensor.
6. REMOVE REAR AXLE HUB & BEARING ASSEMBLY LH
7. REMOVE SKID CONTROL SENSOR
a. Mount the rear axle hub in a soft jaw vise.
NOTICE: Replace the axle hub assembly if it is dropped or a strong shock is given to it.