Corolla L4-1.8L (2ZZ-GE) (2005)
1. Using an ohmmeter, measure the resistance between the coil wires.
Standard: Below 1 Ohm
If the resistance is not as specified, replace the generator drive end frame.
2. Using an ohmmeter, measure the resistance between the coil wire and body.
Standard: 1 MOhm or higher
If the resistance is not as specified, replace the generator drive end frame.
12. REMOVE GENERATOR ROTOR BEARING (1ZZ-FE ENGINE TYPE)
a. Clamp the generator rotor in a vise.
b. Using SST, remove the generator bearing cover (outside) and bearing.
SST 09820-00021
NOTE: Be careful not to damage the fan.
c. Remove the generator bearing cover (inside) from the generator rotor.
13. INSTALL GENERATOR ROTOR BEARING (1ZZ-FE ENGINE TYPE)