Corolla L4-1.8L (2ZZ-GE) (2005)
j.
Connect the transverse engine mounting insulator and engine mounting member sub-assy center to the front suspension crossmember sub-assy.
k. Install the 3 bolts and 3 nuts.
Torque: 52 Nm (530 kgf-cm, 38 ft. lbs.)
12. INSTALL RACK& PINION POWER STEERING GEAR ASSY (LH (A/T) POSITION)
a. Install the rack & pinion power steering gear assy with the 4 bolts.
Torque: 58 Nm (591 kgf-cm, 43 ft. lbs.)
13. INSTALL FRONT SUSPENSION ARM SUB-ASSY LOWER NO.1 LH
a. Install the front suspension arm sub-assy lower No.1 LH with the 2 nuts and bolt to the lower ball joint assy front LH.
Torque: 89 Nm (908 kgf-cm, 66 ft. lbs.)
14. INSTALL FRONT SUSPENSION ARM SUB-ASSY LOWER NO.1 RH (LH (A/T) POSITION)
HINT: Install the RH side by the same procedures as the LH side.
15. INSTALL FRONT STABILIZER LINK ASSY LH (LH (A/T) POSITION)
16. INSTALL FRONT STABILIZER LINK ASSY RH (LH (A/T) POSITION)
HINT: Install the RH side by the same procedure as the LH side.
17. STABILIZE SUSPENSION
a. Install the front wheel and jack down the vehicle.
Torque: 103 Nm (1,050 kgf-cm, 76 ft. lbs.)
b. Bounce the vehicle up and down several times to stabilize the suspension.
18. FULLY TIGHTEN FRONT SUSPENSION ARM SUB-ASSY LOWER NO.1 LH
a. Fully tighten the 2 bolts and nut.
Torque: 137 Nm (1,397 kgf-cm, 101 ft. lbs.)
NOTICE: Tighten the bolt since the nut cannot be rotated.
19. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT