Corolla L4-2.4L (2AZ-FE) (2010)
(f) Remove the chain block and sling device.
(g) Remove the 2 bolts and engine hangers.
23. INSTALL CRANKSHAFT POSITION SENSOR See: Powertrain Management/Computers and Control Systems/Crankshaft Position
Sensor/Service and Repair/Installation
24. INSTALL IDLER PULLEY SUB-ASSEMBLY
(a) Install the idler pulley sub-assembly with the 2 bolts.
Torque : 50 Nm (510 kgf-cm, 37 ft-lbf)
25. INSTALL ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH
(a) Install the engine mounting insulator sub-assembly RH with the 4 bolts and 2 nuts.
Bolt A - Torque : 52 Nm (530 kgf-cm, 38 ft-lbf)
Bolt B - Torque : 95 Nm (969 kgf-cm, 70 ft-lbf)
Nut A - Torque : 95 Nm (969 kgf-cm, 70 ft-lbf)
Nut B - Torque : 52 Nm (530 kgf-cm, 38 ft-lbf)
26. INSTALL EXHAUST MANIFOLD CONVERTER SUB-ASSEMBLY
(a) Install a new gasket onto the cylinder head sub-assembly.
(b) Temporarily tighten the exhaust manifold converter sub-assembly with the 5 nuts.
(c) Tighten the 5 nuts in the sequence shown in the illustration.