Corolla L4-2.4L (2AZ-FE) (2010)
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(c) If the resistance is not as specified, replace the No. 2 heater control (blower switch).
3. INSPECT NO. 3 HEATER CONTROL
(a) Disconnect the connector from the No. 3 heater control.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
HINT
*1: w/ PTC heater
(c) Check that the indicator light comes on.
(1) Connect a positive (+) lead from the battery to terminal 3 and a negative (-) lead from the battery to terminal 4, and check that the indicator