Corolla L4-2.4L (2AZ-FE) (2010)
Standard Resistance (Check for Open):
Standard Resistance (Check for Short):
(d) Reinstall the integration relay.
(e) Reconnect the ignition switch connector.
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR (INTEGRATION RELAY - ECM)
OK -- Continue to next step.
11. INSPECT IGNITION SWITCH
(a) Remove the ignition switch.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(c) Reinstall the ignition switch.
NG -- REPLACE IGNITION SWITCH See: Ignition System/Sensors and Switches - Ignition System/Ignition Switch/Service and
Repair/Components
OK -- REPAIR OR REPLACE HARNESS OR CONNECTOR (IGNITION SWITCH - BATTERY)