Corolla L4-2.4L (2AZ-FE) (2010)
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
NG -- REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (CENTER AIRBAG SENSOR ASSEMBLY
BRANCH WIRE)
OK -- Continue to next step.
2. CHECK HARNESS AND CONNECTOR (IG2, E1, E2)
(a) Disconnect the center airbag sensor assembly connector.
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
(c) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
NG -- REPAIR OR REPLACE HARNESS OR CONNECTOR
OK -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY See: Relays and Modules/Relays and Modules - Restraint Systems/Air
Bag Control Module/Service and Repair/Removal