Corolla L4-2.4L (2AZ-FE) (2010)
(c) Except TMC made:
(1) Measure the resistance according to the value(s) in the table below.
NOTICE:
The resistance must be measured after the CAN No. 1 junction connector is disconnected.
Standard Resistance:
NG -- REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (CAN NO. 1 JUNCTION CONNECTOR - YAW
RATE SENSOR)
OK -- Continue to next step.
15. CHECK FOR SHORT IN CAN BUS WIRES (CAN NO. 1 JUNCTION CONNECTOR - ACCESSORY GATEWAY)
(a) w/ remote engine starter:
(1) Disconnect the accessory gateway connector from the accessory.
(b) TMC made:
(1) Measure the resistance according to the value(s) in the table below.