Corolla L4-2.4L (2AZ-FE) (2010)
/Page-999055.png)
(a) Reconnect the CAN No. 2 junction connector.
(b) TMC made:
(1) Disconnect the CAN No. 1 junction connector.
(2) Measure the resistance according to the value(s) in the table below.
NOTICE:
*
The resistance must be measured after the CAN No. 2 junction connector is reconnected.
*
The resistance must be measured after the CAN No. 1 junction connector is disconnected.
Standard Resistance:
(c) Except TMC made:
(1) Disconnect the CAN No. 1 junction connector.
(2) Measure the resistance according to the value(s) in the table below.
NOTICE:
*
The resistance must be measured after the CAN No. 2 junction connector is reconnected.
*
The resistance must be measured after the CAN No. 1 junction connector is disconnected.
Standard Resistance: