Corolla L4-2.4L (2AZ-FE) (2010)
NOTICE:
The resistance must be measured after the center airbag sensor assembly and CAN No. 1 junction connector are disconnected.
Standard Resistance:
NG -- REPAIR OR REPLACE CAN BUS BRANCH WIRE OR CONNECTOR (CAN NO. 1 JUNCTION CONNECTOR -
CENTER AIRBAG SENSOR ASSEMBLY)
OK -- REPLACE CENTER AIRBAG SENSOR ASSEMBLY See: Relays and Modules/Relays and Modules - Restraint Systems/Air
Bag Control Module/Service and Repair/Removal
20. CHECK FOR SHORT TO GND IN CAN BUS WIRE (CAN NO. 1 JUNCTION CONNECTOR - COMBINATION METER)
(a) Disconnect the combination meter connector.
(b) TMC made:
(1) Measure the resistance according to the value(s) in the table below.
NOTICE:
The resistance must be measured after the combination meter and CAN No. 1 junction connector are disconnected.
Standard Resistance: