Corolla L4-2.4L (2AZ-FE) (2010)
(c) Install the side airbag sensor with the bolt and pin.
Torque : 9.0 Nm (92 kgf-cm, 80 in-lbf)
NOTICE:
*
If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with
a new one.
*
When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched
between other parts.
*
Make sure that the pin is securely inserted into the body hole.
*
Tighten the bolt while holding the side airbag sensor because the side airbag sensor pin (stopper) is easily damaged.
(d) Connect the connector.
NOTICE:
When connecting the airbag connector, take care not to damage the airbag wire harness.
(e) Check that there is no looseness in the installation parts of the side airbag sensor.
2. INSTALL LOWER CENTER PILLAR GARNISH See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
3. CONNECT REAR DOOR OPENING TRIM WEATHERSTRIP See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Installation
4. INSTALL REAR DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
5. CONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP See: Body and Frame/Interior Moulding / Trim/Headliner/Service and
Repair/Installation
6. INSTALL FRONT DOOR SCUFF PLATE See: Body and Frame/Interior Moulding / Trim/Headliner/Service and Repair/Installation
7. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
8. INSPECT SRS WARNING LIGHT
(a) Inspect the SRS warning light See: Testing and Inspection/Initial Inspection and Diagnostic Overview/Diagnosis System.