Corolla L4-2.4L (2AZ-FE) (2010)
*
When installing the seat position sensor, be careful that the SRS wiring does not interfere with other parts and that it is not
pinched between other parts.
HINT
Be sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.0236 in.) to 2.0 mm (0.0787 in.).
(c) Using a "TORX" socket wrench (T30), tighten the "TORX" screw to install the seat position sensor with seat slide position sensor protector.
Torque : 8.0 Nm (82 kgf-cm, 71 in-lbf)
(d) Make sure that the clearance between the seat position sensor and the seat rail is within 0.6 mm (0.0236 in.) to 2.0 mm (0.0787 in.).
(e) Connect the connector.
(f) Check that there are no loose parts after installing the seat position sensor.
3. INSTALL FRONT SEAT CUSHION SHIELD (for Manual Seat) See: Body and Frame/Seats/Service and Repair/Overhaul/Front Seat Assembly
(for Manual Seat)/Reassembly
4. INSTALL VERTICAL ADJUSTING HANDLE (for Manual Seat) See: Body and Frame/Seats/Service and Repair/Overhaul/Front Seat
Assembly (for Manual Seat)/Reassembly
5. INSTALL VERTICAL SEAT ADJUSTER KNOB CAP (for Manual Seat) See: Body and Frame/Seats/Service and Repair/Overhaul/Front Seat
Assembly (for Manual Seat)/Reassembly
6. INSTALL RECLINING ADJUSTER RELEASE HANDLE (for Manual Seat) See: Body and Frame/Seats/Service and Repair/Overhaul/Front
Seat Assembly (for Manual Seat)/Reassembly
7. INSTALL FRONT SEAT ASSEMBLY (for Manual Seat)
(a) Install the front seat assembly See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat Assembly (for Manual
Seat)/Installation.
8. INSTALL FRONT SEAT ASSEMBLY (for Power Seat)
(a) Install the front seat assembly See: Body and Frame/Seats/Service and Repair/Removal and Replacement/Front Seat Assembly (for Power
Seat)/Installation.